Select Water Level - Maytag Performa PAVT-2 Use & Care Manual

Using the Controls – 2 Speed Combo Models
Controls at a glance
Dryer Exhaust tips
STEP 1

Select Water Level

Determine the selected setting based on clothes load
size. Selection should provide sufficient water to permit
clothes to circulate freely during agitation.
It may become necessary, due to bulky fabrics, to
adjust the water level after agitation begins. To adjust
the water level, turn the control to Reset and then
back to the desired setting.
WATER LEVEL SETTING
Mini
Med
Large
Oversize
Note:
Items must circulate freely for best results.
3
Notes
LOAD SIZE
1/4 Full
1/4 – 1/2
1/2 – 3/4
3/4 – Full
STEP 2
Select Cycle and Water
Temperature
To select a cycle and water temperature, push the
control dial in (off position) and turn it to the right
(clockwise) until the pointer is at the number of
minutes and water temperature needed for the wash
load in the Regular, Permanent Press or Delicates
cycles. All rinses are cold water.
Regular Cycle
Used to wash Cottons and heavily soiled items.
Permanent Press Fabrics Cycle
Used to minimize wrinkles with a cool-down spray
rinse following the wash.
Delicates Cycle
Used for items requireing delicate wash action. The
washer will fill, them agitate and soak alternately.
Note:
In wash water temperatures below 60
detergents do not dissolve well or clean well. Care
labels define cold water as up to 85
° F,
°
F.