Brother DCP-7030 User Manual page 63

Error Message
Fuser Error
Init Unable XX
Jam Rear
Jam Inside
Jam Tray
No Paper
Out of Memory
Print Unable XX
Scan Unable XX
Toner Life End
Cause
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
The machine has a mechanical
problem.
The paper is jammed in the back
of the machine.
The paper is jammed inside the
machine.
The paper is jammed in the paper
tray of the machine.
The machine is out of paper or
paper is not correctly loaded in
the paper tray.
The machine's memory is full.
The machine has a mechanical
problem.
The machine has a mechanical
problem.
The drum unit and toner cartridge
assembly is not installed
correctly, or the toner cartridge is
used up and printing is not
possible.
Troubleshooting and routine maintenance
Action
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
Disconnect the machine from the power for
several minutes and then reconnect it.
(See Paper jams on page 57.)
(See Paper jams on page 57.)
(See Paper jams on page 57.)
Do one of the following:
Refill the paper in the paper tray, and
then press Start.
Remove the paper and load it again, and
then press Start.
Copy operation in progress
Do one of the following:
(DCP-7040 and DCP-7045N only)
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See
Out of memory message on page 27.)
Print operation in process
Reduce print resolution. (See Advanced tab
in the Software User's Guide on the
CD-ROM.)
Disconnect the machine from the power for
several minutes and then reconnect it.
Disconnect the machine from the power for
several minutes and then reconnect it.
Do one of the following:
Re-install the toner cartridge and drum
unit assembly.
Replace the empty toner cartridge with a
new one. (See Replacing a toner
cartridge on page 69.)
B
55