Brother DCP-7030 User Manual page 57

Examples of poor print
quality
F G H
A B C D E
h i j k
a b c d e f g
A B C D
a b c d e
0 1 2 3 4
Page skewed
Ghost
B DEFGH
abc efghijk
A C D
b c d e
1 3 4
Wrinkles or creases
ABCDEFGH
abcdefghijk
A B C D
a b c d e
0 1 2 3 4
Poor fixing
Recommendation
Make sure that the paper or other print media is loaded correctly in
the paper tray and that the guides are not too tight or too loose
against the paper stack.
Set the paper guides correctly. (See Loading paper in the paper tray
on page 6.)
The paper tray may be too full.
If you are using the manual feed slot, see Loading paper in the
manual feed slot on page 7.
Check the paper type and quality. (See Acceptable paper and other
print media on page 11.)
Make sure that you use paper that meets our specifications. Rough-
surfaced paper or thick paper may cause the problem. (See
Acceptable paper and other print media on page 11.)
Make sure that you choose the correct media type in the printer driver
or in the machine's Paper Type menu setting. (See Acceptable paper
and other print media on page 11 and Basic tab in the Software
User's Guide on the CD-ROM.)
The drum unit may be damaged. Put in a new drum unit. (See
Replacing the drum unit on page 73.)
The fuser unit may be contaminated. Call your Brother dealer for
service.
Check the paper type and quality. (See Acceptable paper and other
print media on page 11.)
Make sure that paper is loaded correctly. (See Loading paper in the
paper tray on page 6.)
Turn over the stack of paper in the tray or rotate the paper 180° in the
input tray.
Choose Improve Toner Fixing mode in the printer driver. (See
Device Options (For Windows
the Software User's Guide on the CD-ROM.)
If this selection does not provide enough improvement, choose
Thicker Paper in Media Type settings.
Troubleshooting and routine maintenance
®
) or Print Settings (For Macintosh) in
B
49