Zibro S 1326 Operating Manual page 19

man_S13xx_SC13xx.qxd:man_S18xx 24-11-10 12:33 Page 129
Problem
Unit does not start
Unit not cooling or
heating room very well
while air fl owing out
from the air conditioner
Fan speed cannot be
changed
TEMP. Indicator is not
shown
Cause
Power cut
Unit may have become unplugged.
Fuse may have blown.
Battery in Remote controller may have
been exhausted.
Distance remote controller to receiver
on the indoor unit is more than 6 to
7 meters, or there are obstacles in
between the remote controller and the
receiver.
The time you have set with timer is
incorrect.
Inappropriate temperature setting.
Air fi lter is blocked.
Doors or windows in room are open.
Air inlet or outlet of indoor or outdoor
unit has been blocked.
Compressor 3 minutes delay protection
has been activated.
Defrosting of outdoor unit being
performed.
Airconditioner is in automode
Airconditioner is in dry mode
Airconditioner is in fan mode
Solution
Wait for power to be restored.
Check that plug is securely in wall
receptacle.
Replace fuse / reset relay / reset
circuitbraker
Replace the battery.
Shorten the distance. Remove possible
obstacles. Aim the remote controller
towards the receiver on the indoor unit.
Wait or cancel timer setting.
Set temperature correctly. For detailed
method please refer to "operation with
remote control" chapter E.
Clean the air fi lter.
Close the doors or windows.
Clear obstructions away fi rst, then
restart the unit.
Wait.
Fan speed can only be changed in HEAT,
COOL and FAN mode
Temperature cannot be set in FAN
mode
4
129