Table of Contents
Advertisement
2) Binary signals
NSF
Non-Standard Facility
Informs that the receiving station (machine) has a non-standard facility.
NSC
Non-Standard Facility Command
Command to transmit using the non-standard facility which is selected corresponding to NSF (i.e.,
Polling etc.).
NSS
Non-Standard Facility Setup
Command to transmit using the non-standard facility which is selected corresponding to NSF or
NSC.
CSI
Called Subscriber Identification
Provides the telephone number of the called station. Used to check the identity of the called sta-
tion.
CIG
Calling Subscriber Identification
Provides the telephone number of the calling station. Used to check the identity of the calling sta-
tion (Polling, etc.).
TSI
Transmitting Station Identification
Provides the telephone number of transmitting station. Used to check the identity of the transmit-
ting station.
DIS
Digital Identification Signal
Informs that the receiving station (machine) has a standard facility (G3/G2).
DTC
Digital Transmit Command
Command to transmit using the standard facility which is selected corresponding to DIS (i.e., Poll-
ing, etc.).
DCS
Digital Command Signal
Commands to transmit using the standard facility which is selected corresponding to DIS or DTC.
SUB
Sub-address
Indicates that the FIF information is a sub-address in the domain on the call-in side.
SEP
Select Polling
Indicates that the FIF information is a sub-address for the polling mode.
PWD
Password
Indicates that the FIF information is a password for the polling mode in a reception.
Indicates that the FIF information is a password for transmission in a transmission.
CFR
Confirmation of Reception
Informs that the FAX is ready to receive data.
FTT
Failure to Train
Informs that the TCF signal has not received correctly and requests the re-training.
EOM
End of Message
Informs that the the 1st page has been transmitted and there is the next page; command to return
to the beginning of the phase B.
MPS
Multi-page Signal
Informs that the 1st page has been transmitted and there is the next page; command to return to
the beginning of the phase C.
EOP
End of Procedure
Informs that a document has been transmitted and there is no more pages.
MCF
Message Confirmation
A reply to MPS, EOM or EOP; informing that image signals have been received correctly and the
FAX is ready to receive data.
RTN
Retrain Negative
Informs that a document has not been received correctly; requests for the retraining or phase syn-
chronization to receive the next page.
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DIALING/COMMUNICATION CONTROL
3 - 7
3
GD-1220/1221
Advertisement
Table of Contents
