Table of Contents
Advertisement
Congratulations on your purchase of a
new Deadbolt-Activated NAPCO Freedom
Security System.
This revolutionary new
concept in residential security makes using
your system easier than ever before possible,
because the system uses its computerized
control panel to continually monitor the
status of your entry door (and deadbolt). It
actually anticipates what command it should
expect from you next--simply requiring just
one button to press to effortlessly operate
your security system, whether you're going,
returning or staying in for the night.
1
Test your siren and central station communicator:
Hold Down the BYPASS button for 4 seconds (until the F-
TPBR Touchpad beeps). The system will generate a
test report to central station and two momentary chirps
of the siren.
•
If the siren does not sound or sounds week, call for service.
•
If the system indicates a low battery system trouble (trouble light TBL
flashing 2 times), call for service.
•
If the system indicates a communication failure system trouble (TBL
flashing 3 times), call for service. (The communication failure system
trouble may take a few minutes to appear).
A subsequent press of the DISARM/SILENCE button will silence the trouble
indication.
2
I N T R O D U C T I O N
Now everyone in your family, young and
old alike, will enjoy the true peace-of-mind
you would expect from a quality, state-of-the-
art Security System, without the fuss of re-
membering confusing numerical codes to
operate it.
Simplicity and convenience begin with
your System's one-touch STAY or AWAY but-
tons, then just lock or unlock the door as
usual! Day in and day out, that's all there is
to it.
This booklet contains important infor-
mation about the operation of your
IMPORTANT - TEST YOUR SYSTEM WEEKLY
From a Ready Condition (Disarmed State)
2
NAPCO Freedom Security System. Please
read it through and retain it for handy
reference. Because your system is custom-
ized for your home and lifestyle, you may
find subjects mentioned here, that don't ap-
ply to your system. Rest assured your secu-
rity system has been configured by your Se-
curity Professional to best suit you and the
system itself has been meticulously designed
and engineered to the highest industry stan-
dards.
Please test your system at least once a
week as described below.
Test your motion sensors and other protective devices:
Hold Down the BYPASS button for 8 seconds (until the second hold-down
beep).
•
Walk through the areas protected by motion sensors. The F-TPBR
Touchpad will beep when the zone is violated and again when the zone
is restored.
•
Open and close all protected doors and windows and listen for the corre-
sponding F-TPBR Touchpad beeps.
After testing the protective devices, the F-TPBR Touchpad ARMED indica-
tor will flash out the zone number of all zones which have been activated.
Press the DISARM/SILENCE button to clear the display and end the test.
If any devices fail to respond when activated or register on the F-TPBR
Touchpad display as described above, call for service.
Advertisement
Table of Contents
