Operation Notice; Accessibility And Voice Quality - Mitel 5607 User Manual

Mitel 5607 Wireless Handset User Guide

Operation Notice

Accessibility and Voice Quality

The base network is not always available. If you do not get in contact with your system, contact
your system administrator. For best voice quality, avoid positioning near computer, radio or
similar equipment.
Note: Bluetooth uses a frequency of 2.45 GHz. WLAN, microwave oven, and other
devices that use the same frequency can disturb the use of a Bluetooth headset.
Operating Area
You can only use the handset in the area that is covered by your system. Outside this area you
will loose contact with the system. The signal strength icon will be low and "Searching" will
appear.
For Bluetooth, a maximum distance of 10 metres between the headset and the handset is
supported. The communication distance between the handset and headset may vary
considerably due to the environment and disturbances from other 2.45 GHz equipment. The
communication distance can vary across headsets.
Out of Range
When you leave the system's coverage area a short beep soun ds and the text "Searching" will
appear in the display.
The out of range beep will be repeated every minute for 30 minutes. You can turn off the sound
by long pressing
When re-entering the coverage area it can take a couple of minutes before the handset
automatically registered with the system.
For the Bluetooth, If a connection cannot be made with the selected Bluetooth headset, the
call is transferred automatically to the handset.
If the Bluetooth headset and the handset are out of range from each other, the connection is
temporarily lost. Since the last connected headset is always considered "selected", the
connection is automatically established again when a call is made or received. In there is more
than one paired headset in list, the preferred headset used for calls is always first in list.
74
, or .