SAVE THESE INSTRUCTIONS This manual contains instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed these warnings may affect your warranty. UPS Location Warnings • Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust or direct sunlight.
1. Make sure that the UPS is plugged into a live AC outlet. 2. Press the ON/OFF/MUTE/TEST button to start the UPS. (A beep should sound when the UPS starts.) 3. If the UPS still does not start, contact Tripp Lite Tech Support for assistance. Basic Operation “ON/OFF/MUTE/TEST”...
Page 4
If it remains lit after allowing the UPS to charge for twelve hours and running a second self-test, contact Tripp Lite for service. OVERLOAD LED: This red light will illuminate continuously to indicate that the UPS is overloaded when the UPS is providing power from battery or after the UPS runs a self- test.
UPS batteries discharged for a long period of time, they will suffer a permanent loss of capacity. Service A variety of Extended Warranty and On-Site Service Programs are also available from Tripp Lite. For more information on service, visit www.tripplite.com/support. Before returning your product for service, follow these steps: 1.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications to this equipment not expressly approved by Tripp Lite could void the user’s authority to operate this equipment. Note on Labeling Two symbols are used on the label.
GUARDE ESTAS INSTRUCCIONES Este manual contiene instrucciones y advertencias que deben seguirse durante la instalación, operación y el almacenamiento de todos los UPS de Tripp Lite. La falta de observar estas advertencias podría afectar su garantía. Advertencias sobre la ubicación del UPS •...
2. Pulsarlo un botón de “ON/OFF/MUTE/TEST” (“ENCENDIDO/APAGADO/SILENCIO/PRUEBA”) durante al menos un segundo para iniciar el UPS. (Sonará un pitido cuando se encienda el UPS). 3. Si el UPS aún no se inicia, comuníquese con el Soporte Técnico de Tripp Lite para obtener asistencia. Operación básica • Para ENCENDER el UPS: Presione y mantenga el botón “ON/OFF/MUTE/TEST”...
Page 10
Se utilizan con el software PowerAlert de Tripp Lite y con un cable USB adecuado. Es posible que su UPS incluya un cable USB. Puede obtener el software PowerAlert GRATUITAMENTE a través de la Web en www.tripplite.com.
La presente garantía no cubre ningún daño (directo, indirecto, especial o consecuencial) del producto que ocurra durante el envío a Tripp Lite o a un centro de servicio técnico de Tripp Lite autorizado. Los productos enviados a Tripp Lite o a un centro de servicio técnico de Tripp Lite autorizado deben tener prepagos los cargos de transporte.