Problems When Projection Starts - Epson EH-TW420 User Manual

Problem Solving

Problems when projection starts

f
f Power does not turn on
Check
Did you press the [t] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is
touched?
Is the control panel lock set to "Full Lock"?
Was the power cable plugged back in immediately after
Direct Power Off, or is the breaker turned off?
Press the [t] button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally.
Connect the projector's power cable correctly.
Check that your electrical outlet or power source is functioning correctly.
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service
Guide. s Epson Projector Contact List
When you press and hold down the [Enter] button on the control panel for about seven seconds, a message is
displayed and the lock is released. s
When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn
back on. Press the [t] button to turn the power back on.
Remedy
p.27
51