Other Problems - Epson EH-TW420 User Manual

Problem Solving

Other problems

f
f There is no audio or the audio is too low
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
The remote control does not work
f
Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector when it is operated?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps
shining onto the remote receiver?
Are the batteries dead or have the batteries been inserted
correctly?
Was a remote control button pressed for more than 30
seconds?
Check that the cable is connected to the Audio port.
Adjust the volume so that sound can be heard.
Press the [A/V Mute] button on the remote control to cancel A/V Mute. s
When using a commercially available audio cable, make sure it is labelled "No resistance".
Point the remote control towards the remote receiver.
The operating angle for the remote control is about 30 ° horizontally, and about 15 ° vertically.
The operating range for the remote control is about 6 m.
Set the projector up in a location where strong light does not shine onto the remote receiver.
Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s
If any of the buttons on the remote control are pressed down for more than 30 seconds, the remote control
stops sending signals (remote control's sleep mode). When the button is released, normal remote control
operation resumes. This can prevent the batteries from running down accidentally because Sleep Mode
operates when the remote control is stored in a bag or if an object is placed on top of it.
Remedy
p.17
Remedy
52
p.57