Multi Control; Configuring Settings For Multi Control - Samsung ME32C User Manual

Chapter 08
System

Multi Control

MENUm → System → Multi Control → ENTERE
Multi Control
ID Setup
ID Input
MDC Connection RS232C MDC
DisplayPort daisy chain
- The displayed image may differ depending on the model.

Configuring settings for Multi Control

ID Setup
•
Assign an ID to a set. (Range: 0~99)
Press ▲ or ▼ to select a number, and press E.
ID Input
•
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
00
MDC Connection
•
--
Select a method to connect to MDC to receive the MDC signal.
RS232C
-
RJ45
-
DisplayPort daisy chain
•
Clone
To display the DP IN video input through the DP OUT output port, select a device connection method from Single Stream
Transport (SST) and Multi Stream Transport (MST).
Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devices
connected.
― If
Clone
―
Clone mode is enabled if the input source is a digital input other than DisplayPort, such as DVI,
Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devices connected.
― If
Expand
― The mode functions only on a PC that supports DisplayPort 1.2 MST.
― For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.
MDC: Communicate with MDC via the RS232C-stereo cable.
MDC: Communicate with MDC via the RJ45 cable.
is selected, the PC recognizes the two displays as a single monitor.
is selected, the PC recognizes the two displays as separate monitors.
HDMI or MagicInfo.
120