Table of Contents
Advertisement
b.
If your are installing a media card reader, connect the USB cable to the USB system board
connector labeled MEDIA.
Figure 6-19
8.
If installing a new drive, connect the opposite end of the data cable to the appropriate system
board connector.
NOTE:
drive to the white SATA connector on the system board labeled SATA2. Connect the data cable
for a second optical drive to the black SATA connector on the system board labeled ESATA. If
the ESATA connector is already populated, connect the second optical drive to white connector
labeled SATA1.
Refer to
connectors.
9.
Replace the front bezel and computer access panel.
10.
Reconnect the power cord and any external devices, then turn on the computer.
11.
Lock any security devices that were disengaged when the access panel was removed.
74
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Connecting the Media Card Reader USB Cable
If you are installing a new SATA optical drive, connect the data cable for the first optical
System Board Connections on page 67
for an illustration of the system board drive
Hide quick links:
Advertisement
Table of Contents
