Cisco ME 3800X Installation Manual page 37

Chapter 2 Switch Installation
Figure 2-12
1
Grasp the SFP+ or SFP module, and carefully remove it from the module slot.
Step 5
For fiber-optic SFP+ or SFP modules, insert a dust plug into the optical ports of the SFP+ or SFP module
Step 6
to keep the optical interfaces clean.
Place the removed SFP+ or SFP module in an antistatic bag or other protective environment.
Step 7
Inserting and Removing the SFP+ Module Patch Cable
This section shows how to install and remove an SFP+ module patch cable into an SFP+ (uplink) module
Note
slot. The procedure is the same for installing an SFP module patch cable into an SFP (downlink) module
slot.
To insert an SFP+ module patch cable into the SFP+ module slot, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 1
Insert the SFP+ module patch cable into the slot until you feel the connector on the cable snap into place
Step 2
in the rear of the slot (see
OL-22168-01
Removing a Bale-Clasp Latch SFP+ Module
1
Bale clasp
Figure
Inserting and Removing the SFP+ Module Patch Cable
1
2
2-13).
Cisco ME 3800X and ME 3600X Switch Hardware Installation Guide
2-17