Maintenance; Maintaining Your Stove's Appearance; Battery Replacement - Lopi GreenField Owner's Manual

Maintenance

38

Maintaining Your Stove's Appearance

Painted Surfaces
• Painted surfaces should be cleaned with a duster. If scratches occur, lightly sand the area with fine sandpaper.
Clean the area and, with the stove cool, apply one or two thin coats of stove paint to the area (mask the area to
avoid overspray). Allow the stove to dry, then turn the stove on to cure the paint (1 hour on medium).
Enamel Surfaces
• Use only soft cloth and water to clean enamel surfaces. To fix chips in the enamel, follow the directions below:
1) Let the stove cool. Clean the area thoroughly.
2) Shake the Travis Enamel Touch-Up thoroughly. Apply to the damaged area.
Glass
• Clean the glass with soap and water (do not use abrasive cleaners). To remove the glass, follow the instructions
on page 26.

Battery Replacement

Power Backup Batteries
Four AA batteries are used as a power backup for the stove in case the household (AC) power goes out. They also
power the comfort control feature. These batteries must be inserted into battery holder (make sure they contact the
terminals - see the illustration below). The fireplace controller will beep once these batteries start to go dead.
Replace batteries before each heating season to insure proper operation.
Control Panel Light Battery
LED lights and a 9v battery are used to illuminate the control panel when the concealment cover is lifted. If the LED
lights do not operate, replace the 9v battery (see the illustration below). The battery holder is held in place with Velcro
and may be removed for easier access.
Swing the control
cover down to
access the batteries.
© Travis Industries
(for qualified service personnel only)
Battery Holder for
Control Panel Lights
4101028
AA
Battery
Holder
AA Battery Tray
100-01255_000