Remote Controller - Hitachi RAS-30CHP6 Instruction Manual

NAMES AND FUNCTIONS OF EACH PART

REMOTE CONTROLLER

This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
G
Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sign blinks when a signal is sent.
G
Display
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
G
START/STOP button
Press this button to start operation. Press it again to stop operation.
G
FAN SPEED selector
This determines the fan speed. Every time you press this button, the intensity
of circulation will change from
(during the (FAN) mode, from
G
AUTO SWING button
Controls the angle of the horizontal air deflector.
G
TEMPERATURE buttons
Use these buttons to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
G
SLEEP button
Use this button to set the sleep timer.
G
TIME button
Use this button to set and check the time and date.
G
RESET buttons
G
FUNCTION selector
Use this button to select the operating mode. Every time you press it,
the mode will change from
(COOL) and to
G
PARALLEL SWING button
Controls the angle of the vertical air deflectors to parallel.
G
SYMMETRY SWING button
Controls the angle of the vertical air deflectors to symmetry.
G
TIMER control
Use this button to set the timer.
G
OFF-TIMER button
G
ON-TIMER button
G
RESERVE button
G
CANCEL button
Precautions for Use
G
Do not put the remote controller in the following places.
G
In direct sunlight.
G
In the vicinity of a heater.
G
Handle the remote controller carefully. Do not drop it on the floor,
and protect it from water.
G
Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the power
cord and plug it in again).
This is to protect the device and does not indicate a failure.
G
If you press the FUNCTION selector button during operation, the
device may stop for about 3 minutes for protection.
(AUTO) to
HI to
(AUTO) to
(FAN) cyclically.
Select the turn OFF time.
Select the turn ON time.
Time setting reservation.
Cancel time reservation.
– 6 –
(HI) to (MED) to
MED to LOW).
(HEAT) to (DEHUMIDIFY) to
(LOW)