Carrier Activation - Multitech MultiModem rCell Quick Start Manual

MultiModem rCell Intelligent Wireless Router
Init String –
PPP Authentication
Authentication Type –
authentication protocol you want to use to negotiate with the remote
peer. PAP, CHAP, or PAP-CHAP.
Default = PAP-CHAP
User Name –
peer).
Password –
peer).
Important Note About Submit and Save & Restart
Click the Submit button located at the bottom of most screens to
save any changes you make. Then you must click the Save &
Restart button in order for your settings to take effect. Save &
Restart does not have to be executed after each screen; you can
change and Submit several screens, and then click Save &
Restart. The Save & Restart button is located on the Menu bar.
Shutdown Caution
Never unplug the power until after you have performed the Save &
Restart process when changing settings. If setup changes are not
properly saved before unplugging the power, data could be lost.

Carrier Activation

Account activation depends on the carrier that you are connecting to. This
activation process can start as soon as the router receives a good signal
from the carrier. This process can start when power is applied to the router.
Ensure that once you have applied power to the router, you do not power
down or reset the device until after you have verify network connectivity.
So after you have set up your Ethernet connection and configured the Web
Management Software, this activation process could already be complete.
When you Telnet into the router to verify signal strength, check network
registration and roaming status, you can issue commands to the router to
verify network connectivity.
10
4 modem initialization strings are allowed.
Click the button corresponding to the
Enter the PPP User Name (it authenticates the remote
Enter the PPP Password (it authenticates the remote
Multi-Tech Systems, Inc. Quick Start Guide