How To Set Up Your Machine For Shampooing - Electrolux WET & DRY EXTRACTION VACUUM CLEANERS Owner's Handbook Manual

when operating the vacuum
cleaner as a wet suction cleaner.
If the suction regulator (12) is
open water can be ejected
through it.
14. Once you have completed using
your vacuum cleaner for wet
suction, perform the operation
shown in fig. 16 with the vacuum
cleaner still switched on. This
operation should be performed
carefully alongside a drain for
about 30 seconds to ensure that
all the water is collected in the
bucket (5). You may now empty
the bucket (5) and dry it
thoroughly.
NOTE: If the foam filter (16) is dirty
wash it then dry it. The foam filter
(16) should be changed if it is
damaged. The accessories used
should also be washed and then
dried before being put away.
IMPORTANT. Automatic Shut
Off Valve. When the liquid level
in the bucket (5) exceeds the
safety level the Automatic Shut
Off Valve will operate. This will
cause loss of suction and a
slight change in noise level of
the motor. When this happens,
switch off the power and empty
the bucket (5).
30 sec
Fig. 16
HOW TO SET UP YOUR
MACHINE FOR SHAMPOOING
1. First vacuum or sweep the
surface you intend shampooing.
2. Assemble your machine using
the components shown in fig.3.
3. Fit the foam filter (16) ensuring
it completely covers the float
cage. See fig. 13.
4. Fill the solution tank (22) with
the correct ratio of shampoo and
cold water. Refer to instructions
/directions supplied with the
shampoo you intend using.
NOTE: Make sure that the shampoo
is not hazardous to the surface you
intend using it on.
5. Fit the solution tank (22) inside
the bucket (5) on the opposite
side to the hose intake (9). See
fig. 17.
6. Fit the hood assembly (1) onto
the bucket (5) ensuring that the
solution filter (8) is at the
lowest possible part of the
solution tank (22). See fig. 18.
9
Fig. 17