Hints And Information; How To Order Repair Parts - Williams 3144030 Owner's Manual

Hints and Information

If your heater fails to work correctly, you may avoid inconvenience and the cost of a service call by checking the following points before
you call for service.
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
POSSIBLE CAUSE
If your heater is not heating or not giving enough heat:
Thermostat is not set correctly:
Air flow restricted:
If fan does not run:
Fuse is blown:
Blower motor not connected to electric power:
If blower is noisy:
Housing rattling:
Blower fan dirty:
Blower fan bent:
Motor needs oiling:

How to Order Repair Parts

When ordering repair parts, always give the following Information:
1. Model number
2. Mfg. Date code
3. Part number
4. Part description
All parts listed herein may be ordered from your equipment supplier. The model number of your Williams wall heater will be found on the
name plate.
Williams Furnace Company • 250 West Laurel Street, Colton, CA 92324
(909) 825-0993 • FAX: (909) 824-8009
Manufactured in the U.S.A. • Established 1916
20
For Your Safety
Always disconnect heater circuit switch before opening heater for
inspection or service.
WHAT TO DO
Reset thermostat to desired setting.
Check that doors, drapes or furniture are not blocking louvers.
Replace fuse.
Connect to electric power.
Tighten screws.
Clean blower fan.
Straighten or replace.
Oil motor (Page 15)
P321008, August 2013