Set-Up & Installation - SCIFIT STEP ONE Operation Manual

ATTENTION
Depending on the regular operation of the
machine, the StepOne may require the AC wall
pack to be plugged into the machine at all times.
The following guidelines show typical conditions
that would require use of the AC wall pack with
shorter stride rates requiring more steps per minute:
1. A full step stride of 11.5" below 40 Steps per Min.
2. A half step stride of 6" below 80 Step per Minute
CAUTION
Additional personnel may be required to move the machine.
Placement on an unstable sub-floor without a proper safety
perimeter can result in injury to yourself and others.
Placement of Cardiovascular Machine
The StepOne has two transport wheels located in the front
of the machine and can be moved by grabbing the lift handle
at the rear of the machine.
LIFT
HANDLE
Position the unit in a location that has a stable and level
sub-floor. Equipment should be positioned in a location
that is not in direct sunlight, extreme temperatures and
humidity or where it may be splashed with water or fluids.
This machine is intended for indoor use only.
SCIFIT Scientific Solutions For Fitness
SPECIFICATIONS
SETUP & INSTALLATION
4
SCIFIT
Level Cardiovascular Machine
If the sub-floor is unlevel, the unit is equipped with leveling
end caps. The end caps are designed with the recess of the
end cap off centered. This allows you to rotate the endcap(s)
to a position that will level the equipment. After adjustment,
check and make sure end caps are fully seated against base
frame tubes.
Offset Endcap
The StepOne should be positioned with a safety perimeter
of 1 meter around the unit (see diagram).
Endcap
1m
Spacing
Scientific Solutions For Fitness
1m
Spacing
1m
Spacing
SCIFIT
Endcap
1m
Spacing