Connecting An Audio Device - Denon DN-F400 Operating Instructions Manual

■ Connecting the DN-F400 and RC-
F400S
• Use the RS-232C straight cable supplied
with the RC-F400S.
• After connecting, fix the connector by
turning the screws on the connector.

■ Connecting an audio device

• Connect an audio device to the analog
audio output jacks using the analog audio
cables.
• For audio connections, balanced type
and unbalanced type are available.
For connecting to the balanced output
connectors, use the included PHOENIX
plugs.
• After connecting, adjust the output level,
using a Phillips screwdriver as required.
• Adjust the output level of both balanced-
and unbalanced-type connectors.
Connection precautions
• Before proceeding with connections
or disconnections of cables and AC
adaptor, be sure to turn all system
components off.
• Ensure that analog audio cables are
connected properly to the L (left) and R
(right) jacks.
• Insert plugs fully into the terminals.
• Connect the output jacks to the amplifier
CD or AUX input jacks.
Cautions:
• Before connection, set the POWER
ON/OFF switch to OFF.
• Do not touch the power cord with wet
hands.
• When disconnecting the power cord,
always make sure that you take hold
of the plug. Yanking out or bending the
cord can damage it and/or cause electric
shocks or a fire.
■ Attaching the power cord
holder
• The procedures below are for the DN-
F400.
• For the RC-F400S, attach the holder
turning it by 90-degree.
1. Connect the plug of the AC adaptor to
the DC power inlet.
2. Pass the hole of the power cord holder
to the cord of the AC adaptor. Then
insert the holder to the mounting hole.
Mounting hole
3. Fix the holder to the DN-F400 using the
included screw.
■ Inserting an SD card
1. Turn the DN-F400 on using the POWER
ON/OFF switch.
2. Remove the SD card cover fixing screws,
and remove the cover.
SD card cover
3. Insert an SD card in the SD card slot, and
push it until locked.
SD card
P G M
0 0 :
R P
T
M U S
H o n IC \
e y . M
P 3
2. PREPARATIONS
4. Attach the SD card cover using the
screws if necessary.
■ Removing an SD card
1. Press the 7 button if the unit is in playback
status. If the unit is being operated, wait
until operation is completed.
2. Remove the SD card cover fixing screws,
and remove the cover.
P G M
0 0 :
R P
T
M U S
H o n IC \
e y . M
P 3
SD card cover
3. Push the SD card to remove it.
P G M
0 0 :
R P
T
M U S
H o n IC \
e y . M
P 3
P G M
0 0 :
R P
T
M U S
H o n IC \
e y . M
P 3
P G M
0 0 :
R P
T
M U S
H o n
IC \
e y . M
P 3
7