Advertisement
Installing or removing battery cartridge
Always switch off the tool before insertion or removal of the battery cartridge.
.To
remove the battery cartridge, pull out
the set plate on the bottom of the tool
and grasp both sides of the cartridge
while withdrawing
it
from the barrel.
.To
insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the
set plate
back into place.
Be sure to close the set plate fully before
using the tool.
Set
plate
0
Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides
as
their
respective markings on the fast charger. In-
sert the cartridge fully into the port
so
that
it
rests on the charger port floor.
The charging light will come on and charg-
ing will begin. If the charging light does not
come on,
press
the
reset
button. If the
charging light goes out within 10 seconds even after pressing the reset button
a
couple
of
times, the battery cartridge i s dead. (CAUTION : Wait for more than 5 seconds after the
charging light goes out to press the reset button again.) Replace it with a new one. When
the charging light goes out after about one hour, you may remove the fully charged
battery cartridge. After charging, unplug the charger from the power source.
CAUTION
:
0
Your new battery cartridge is not charged. You will need to charge
it
before use.
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs,
let
the cartridge cool off for
a
while. Then re-insert it
and try to charge
it
once more.
When you charge a new battery cartridge or
a
battery cartridge which has not been used
for
a
long period,
it
may not accept
a
full charge. This
is a
normal condition and does
not indicate a problem. You can recharge the battery cartridge fully after discharging
it completely a couple of times.
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
5
Advertisement
