Upgrade Succeeded; Upgrade Failed - ATEN CS82U User Manual

Upgrade Succeeded

After the upgrade has completed, a screen appears to inform you that the
procedure was successful:
Click Finish to close the Firmware Upgrade Utility.
After a successful completion, the CS82U / CS84U exits Firmware Upgrade
Mode, and resets itself.

Upgrade Failed

If the Upgrade Succeeded screen doesn't appear, it means that the upgrade
failed to complete successfully, in which case you should do the following:
1. Press and hold the Port 1 selection pushbutton. While you are holding the
pushbutton, connect the CS82U / CS84U to the computer using the USB
cable of the custom cable set (see diagram, page 25) to enter Firmware
Upgrade Mode. The front panel LEDs flash to indicate that Firmware
Upgrade Mode is in effect.
2. Run the upgrade again. See Starting the Upgrade, page 27.
6. The Firmware Upgrade Utility
29