Assembly And Set-Up; Attaching The Handlebars; Charging The Battery - Razor E100 Owner's Manual

ASSEMBLy AND SET-UP

q Attaching the Handlebars
1
Open the quick release.
q Inflating the Tire
The front tire is inflated when shipped, but it invariably may lose some pressure between the point of
manufacturing and your purchase.
1
Using a bicycle style tire
pump equipped for a Schrader-
type valve, inflate the front tire
to the correct PSI indicated on
the sidewall of the tire.
q Charging the Battery
Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery
prior to use.
• Initial charge time: 18 hours
• Recharge time: up to 12 hours
When the scooter is not in regular
use, recharge the battery at least
once a month until normal use is
resumed.
Charger
Charger
Port
Charger
Plug
(a)
2
Depress the push button (a)
located on the front fork and
insert the handlebar stem until
the button locks securely into
the fork.
• Run time: Up to 40 minutes of continuous ride time
• Average battery life: 250 charge/discharge cycles
1
Turn power OFF before
charging. Plug the charger into
the charger port on the electric
scooter.
3
Adjust the tension of the
quick release to where you can
close the lever all the way to
secure the stem.
2
Plug the charger into a wall
outlet. If the lights on charger
do not light up, check the power
to the outlet. If necessary, try a
different outlet.
3
Note: Make sure the cables/
wires are out of the way before
inserting the stem into the fork.
Note: The pressurized air
supplies found at gasoline
stations are designed to inflate
high-volume automobile tires.
If you decide to use such an
air supply to inflate the tire,
first make sure the pressure
gauge is working, then use very
short bursts to inflate to the
correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
WARNING: Always
disconnect your scooter from
the charger before cleaning with
liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status.
Refer to the illustration on
the charger unit for the actual
"charging" and "charged" status
indications for your model
charger.
Chargers have built-in over-
charge protection to prevent
battery from being over-charged.
Charger will get warm during
use. This is normal for some
chargers and is no cause for
concern. If your charger does
not get warm during use, it does
not mean that it is not working
properly.
WARNING: Failure
to recharge the battery at least
once a month may result in
a battery that will no longer
accept a charge.