Assembly And Set-Up - Razor Rollie Owner's Manual

ASSEMBLY AND SET-UP

Adjusting the Handlebars
1
To adjust the height of the
handlebars, open the quick-
release lever.
Note: The tension of the quick- release lever can be adjusted by manually
tightening or loosening the Allen bolt. Be careful not to over-tighten. You
should always be able to open and close the quick-release lever by hand and
the T-bar should slide freely when the quick-release is open.
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
2
Slide the T-bar to the desired
position and resecure the quick-
release lever to lock into place. When
the T-bar is raised to the maximum
height, depress the push button
located directly below the quick-
release lever to unlock the T-bar.
3
Close the quick-release lever.
5
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.