Table of Contents
Advertisement
No.
Component
1
Power LED
2
Port LEDs
3
LAN LEDs
4
Laptop USB
Console Port
5
USB Ports
6
Reset Switch
7
Audio Ports
8
Port Switching
Buttons
Lights when the unit is powered up and ready to operate.
The Port LEDs provide status information about their
corresponding KVM Ports.
GREEN: The computer attached to the port is On Line.
RED: The computer attached to the port is Selected (has KVM focus).
GREEN + RED (ORANGE): The computer attached to the port is On
Line and Selected.
The LEDs are steady under normal conditions. A LED will flash
at half second intervals, however, when its corresponding port
is accessed under Auto Scan Mode or Skip Mode.
Primary and Secondary 10/100/1000 Mbps LAN LEDs.
RED: 10 Mbps
RED + GREEN (ORANGE): 100 Mbps
GREEN: 1000 Mbps
Flashes to indicate that the switch is being accessed over the Net.
This mini-USB port allows a laptop to be connected for local
access and control. See Laptop USB Console Login, page 48
for further details.
A USB keyboard and mouse can plug in here. This can either
be in place of, or in addition to, plugging a keyboard and mouse
into the ports on the rear panel. This port can also be used to
connect USB storage peripherals (CD/DVD, HD, flash drives,
etc.) on the V series switches.
Note: This switch is recessed and must be pushed with a small
object such as the end of a paper clip, or a ballpoint pen.
Pressing and releasing this switch when the unit is running
performs a system reset.
Pressing and holding this switch in for more than three
seconds when the unit is running resets its configuration to
the factory default settings.
Note: This does not clear User Account information. See Clear Login
Information, page 246, for information on clearing user
account information.
Pressing and holding this switch while powering on the
switch returns the unit to its factory default firmware level,
rather than the firmware version that the switch has been
upgraded to. This allows you to recover from a failed
firmware upgrade and gives you the opportunity to try
upgrading the firmware again.
Note: This operation should only be performed in the event of a
firmware upgrade failure that results in the device becoming
inoperable.
Speakers and microphone plug in here.
Press PORT DOWN to switch from the current port to the
previous port on the installation.
Press PORT UP to switch from the current port to the next
port on the installation.
Chapter 1. Introduction
Description
10
Advertisement
Table of Contents
