Toyota Sienna 2006 Operating Manual page 525

HomeLinkE
25 to
75 mm
(1 to 3 in.)
Hand- held
garage
transmitter
2. Place your hand- held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
R
the surface of the HomeLink .
Keep the indicator light on the HomeLink
in view while programming.
06 SIENNA_U (L/O 0603)
3. Simultaneously press and
hand- held garage transmitter
along with the selected HomeLink
R ton.
Do not release the buttons until step 4
has been completed.
4. When the indicator light
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
hold the 5. Test the operation of the HomeLink
button pressing the newly programmed button.
R
but- If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
on the
"Rolling Code" type. Press and hold the
programmed HomeLink
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
2006 SIENNA from March '06 Prod. (OM45443U)
R
by
R
button. The ga-
R
)
329