Toyota Sienna 2006 Operating Manual page 165

Hide thumbs Also See for Sienna 2006:
Table of Contents

Advertisement

To continue the operation, do the follow-
ing:
1. Open the back door when the ignition
key is in "LOCK" or "ACC" and/or the
automatic transmission selector lever is
in "P".
2. Push and hold the stowing switch.
To operation stops,
the
indicator
above the switches comes on and a beep
sounds for about 10 seconds if any of the
following condition occur during the opera-
tion:
"
When the stowing switch is released.
"
When the folding/returning switch, re-
turning switch or seatback adjusting
switch is pushed while the stowing
switch is being pushed.
"
When the ignition key is turned to the
"ON" position and the automatic trans-
mission selector lever is moved from
the "P" position.
"
When the automatic transmission selec-
tor lever is in the "N" position and the
ignition key is turned to the "ON" posi-
tion.
If the engine is started during operating,
the seat operation may also be stopped.
06 SIENNA_U (L/O 0603)
If an object is caught between the seat-
back and seat cushion, the indicator
light above the switches flashes and a
beep sounds for about 10 seconds. Re-
move the object before operating the
seat again.
If the indicator light above the switches
flashes even though there is no object
light
between the seatback and seat cushion,
contact your Toyota dealer.
If an object is caught between the seat
and floor, the object prevents the seat
from moving. Do not continue the op-
eration. Remove the object before oper-
ating the seat again.
When the seat is already folded, the seat
can be stowed using the same procedure.
If an object is caught between the seat-
back and seat cushion, the stowing opera-
tion will not start.
After stowing the seats, open the flaps as
shown in the illustration.
2006 SIENNA from March '06 Prod. (OM45443U)
101

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents