3-Pin To 5-Pin Conversion Chart; Setting Up A Dmx Serial Data Link; Master/Slave Fixture Linking - Chauvet Intimidator Spot 150 User Manual

3-PI N T O 5-PI N CO NVERSI O N CHART
Note!
3 P 5 P
IN TO
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
Setting up a DMX Serial Data
Link
1. Connect the (male) 3 pin connector side of
the DMX cable to the output (female) 3 pin
connector of the controller.
2. Connect the end of the cable coming from
the controller which will have a (female) 3
pin connector to the input connector of the
next fixture consisting of a (male) 3 pin
connector.
3. Then, proceed to connect from the output
as stated above to the input of the following
fixture and so on.
CHAUVET Certified DMX Data Cables
Order Code
DMX1.5
DMX4.5
DMX10

Master/Slave Fixture Linking

1. Connect the (male) 3 pin connector side of the DMX cable to the output (f emale) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
Often, the setup for Master-Slave
and Standalone operation requires
that the first fixture in the chain be
initialized for this purpose via either
settings in the control panel or DIP-
switches. Secondarily, the fixtures
that follow may also require a slave
setting. Please consult the
"Operating Instructions" section in
this manual for complete instructions
for this type of setup and
configuration.
Intimidator™ Spot 150 User Manual
If you use a controller with a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter.
CHAUVET Model No: DMX5M, or DMX5F.
The chart below details a proper cable conversion:
C C
IN ONVERSION HART
3 Pin Female (output)
Pin 1
Pin 2
Pin 3
Description
DMX Cable 1.5m/4.9ft
DMX Cable 4.5m/14.8ft
DMX Cable 10m/32.8ft
Slave
11
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
Universal DMX Controller
Continue the link
Slave
This drawing provides a
general illustration of the
DMX Input/Output panel of
a lighting fixture.
Master
6/19/2009 9:08 AM