Use; Start And Stop; Adjusting The Cutting Height - Husqvarna Auto Mower Operator's Manual

Start and stop

!
WARNING!
There are rotating blades under the Auto
Mower. Never put your hands or feet close to
or under the body of the Auto Mower while
the motor is running.
!
WARNING!
Read carefully through the safety regulations
in this Operator's Manual before you start the
Auto Mower.
Starting the Auto Mower
The battery must be charged before starting when the Auto
Mower is new or has been stored for a long period, see "Charg-
ing an empty battery". In other cases the Auto Mower can be
started at any time within the mowing area, according to the
following:
• Lift the cover and switch on the switch. A long beep should be
heard.
• Enter your personal code,
0000 #, see the "Settings" section to select your personal
*
code.
• Lower the cover. The Auto Mower will either immediately start
to mow or seek out the charging station. If the Auto Mower
travels to the charging station with a fully charged battery it
will leave after a short while. If the battery needs to be
charged, it will remain there for sometime before leaving the
charging station.
Stopping the Auto Mower
STOP
• Stop the Auto Mower by folding up the cover. Enter the first
digit of the code to deactivate the theft alarm. Otherwise the
alarm will start after approx. 6 seconds. The long beep
confirms that cutting disc has stopped.
• Restart the Auto Mower by lowering the cover again.
• Always set the power switch to "STOP" if you intend to carry
out any maintenance on the Auto Mower or to move it outside
of the mowing area. When the switch is set to on, the per-
sonal code, code #, must be entered.
*
code #. On delivery the code is
*

USE

Adjusting the cutting height

STOP
The cutting height can be adjusted to any height between
around 3 (setting 1) and 9 cm (setting 5), which is roughly
equivalent to 4–10 cm for a heavier petrol-driven mower.
• Switch off the Auto Mower by lifting the cover, entering the
first code digit of the code and switching off the switch.
• Turn the Auto Mower upside down and place it on a soft
surface.
• Unscrew and loosen the height adjustment knobs to adjust
the cutting height. Move the entire cutting motor up or down
until the desired cutting height is reached. Then re-tighten the
adjustment knobs.
11
English –