Operation; How To Light The Fire; How To Turn Off The Fire - Harman Stove Company Harman Clarity 828i Installation And Operating Manual

How to Light the Fire

1. STOP! Read the safety information on the
lighting instructions label on the stove.
. If using the optional thermostat, set thermostat
to the lowest setting.
3. Turn off electric power to the appliance.
4. Turn the ON-OFF/THERMOSTAT switch to
the OFF position.
5. Push in the gas control knob slightly and turn it
clockwise to "OFF."
NOTE: The knob cannot be turned from "PILOT"
to "OFF" unless it is pushed in slightly. Do not
force it.
6. Wait five (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow "B" in the safety
information on the swing-out label. If you don't
smell gas, go to the next step.
7. Set the High-Low Regulator to High by turning
it fully counterclockwise.
8. Press in the gas control knob slightly and turn
counterclockwise to "PILOT."
9. Find the pilot by looking through the round
opening on the left end of the center log.
10. Push the control knob fully down and hold.
Immediately push the red piezo ignitor button to
light the pilot. It is normal to have to push the red
button several times before the pilot ignites. Con-
tinue to hold the control knob in for about one (1)
minute after the pilot is lit. Release the knob and it
will pop back up. Pilot should remain lit. If it goes
out, repeat steps 5 through 9.
• If the knob does not pop up when released, stop
and immediately call your service technician or gas
supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
11. Turn the gas control knob counterclock-
wise to the "ON" position.
1. Place the ON-OFF/THERMOSTAT switch in
the "ON" position or in the "THERMOSTAT" posi-
tion if the optional thermostat is used.
13. Turn on the electric power to the heater.
14. Set the optional thermostat to the desired
room temperature.

OPErATION

15. Set the High-Low Regulator to desired setting:
turn fully counterclockwise for High and fully clock-
wise for Low.
NOTE: An odor resulting from the initial heat-
ing of new materials in your heater is not unusual
during the first fire, and in most cases will disap-
pear after an hour or two.

How to Turn Off the Fire

1. If using an optional thermostat, set thermostat to
the lowest position.
. Turn off the electric power to the appliance.
3. Turn the ON-OFF/THERMOSTAT switch to the
OFF position.
4. Push in the gas control knob slightly and turn it
clockwise to "OFF."
NOTE: The knob cannot be turned from "PILOT"
to "OFF" unless it is pushed in slightly.
Do not force it.
●FOR YOUR SAFETY: WHAT TO DO IF YOU
SMELL GAS
• Do not try to light any appliance.
• Open windows.
• Extinguish any open flame.
• Do not touch any electrical switch; do not
use any phone in your building. Follow the gas
supplier's instructions.
• If you can not reach your gas supplier, call the
fire department.
Hi/Low Regulator
On/Off/Pilot Knob
1