Operation - Harman Stove Company HB 38 DV Installation And Operating Manual

High-Low
Gas Control
Rear Burner
ON/OFF
Switch Piezo Ignitor
Button
PILOT

OPERATION

Operation
HOW TO LIGHT THE FIRE
1. STOP! Read the safety information on the
front cover.
2. If using the optional thermostat, set thermostat
to the lowest setting.
3. Turn off electric power to the appliance.
4. Turn the ON-OFF/THERMOSTAT switch to
the OFF position.
5. Push in the gas control knob slightly and turn it
clockwise to "OFF." NOTE: THE KNOB
CANNOT BE TURNED FROM "PILOT" TO
"OFF" UNLESS IT IS PUSHED IN SLIGHTLY.
DO NOT FORCE IT.
6. Wait five (5) minutes to clear out any gas. If
ON-OFF/
you then smell gas, STOP! Follow "B" in the
THERMOSTAT
Switch safety information on the front cover. If you
don't smell gas, go to the next step.
7. Set the High-Low Regulator to High by turning
it fully counterclockwise.
8. Press in the gas control knob slightly and turn
counterclockwise to "PILOT."
9. Find the pilot by looking through the round
opening on the left end of the center log.
10. Push the control knob fully down and hold.
Immediately push the red piezo ignitor button to
light the pilot. It is normal to have to push the
red button several times before the pilot ignites.
Three Speed
Continue to hold the control knob in for about
Blower Switch
one (1) minute after the pilot is lit. Release the
knob and it will pop back up. Pilot should
remain lit. If it goes out, repeat steps 5 through
9.
•If the knob does not pop up when released, stop
and immediately call your service technician or
gas supplier.
•If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call your
service technician or gas supplier.
11. Turn the gas control knob counterclockwise to
"ON."
12. Place the ON-OFF/THERMOSTAT switch in
the ON position or in the THERMOSTAT
position if the optional thermostat is used.
13. Turn on the electric power to the heater.
14. Set the optional thermostat to the desired
6