Table of Contents
Advertisement
LAN1/LAN2 Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the LAN1 port and
JPL2 to enable or disable the LAN2
port on the serverboard. See the table
on the right for jumper settings. The
default setting is enabled.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
Watch Dog Enable/Disable
JWD enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will have
WD reboot the system if a program
freezes. Jumping pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Chapter 5: Advanced Serverboard Setup
LAN1/2 Enable/Disable
Jumper Settings (JPL1/2)
Jumper Setting
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user must
write their own application software to disable the
Watch Dog Timer.
5-17
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Reset
NMI
Disabled
Advertisement
Table of Contents
