Using Homelink - RAM 1500 2012 Owner's Manual

194 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
3. Simultaneously press and hold both the Homelink
button while you press and release ("cycle"), your hand-
held transmitter every two seconds.
4. Continue to hold buttons until the EVIC display
changes from "CHANNEL # TRAINING" to "CHAN-
NEL # TRAINED", then release both buttons.
NOTE:
• It may take up to 30 seconds or longer in some cased
for the channel to train.
• If the EVIC displays "DID NOT TRAIN" repeat from
Step 2.
5. Press and hold the programmed HomeLink button.
The EVIC will display "CHANNEL # TRANSMIT". If the
device is plugged in and activates, programming is
complete.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the EVIC displays "CHANNEL # TRAINING" Do not
release the button.
3. Without releasing
"Canadian/Gate Operator Programming" Step 2 and
follow all remaining steps.

Using HomeLink

To operate, press and release the programmed
HomeLink button. Activation will now occur for the
programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.
the button proceed with