Master/Slave Configuration - ADJ Mega Tri 60 User Instructions

Mega Tri 60
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave
mode. In Master-Slave operation one unit will act as the controlling unit
and the others will react to the controlling units built-in programs. Any
unit can act as a Master or as a Slave however, only one unit can be pro-
grammed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR data cables to link your units together. Remember
that the Male XLR connector is the input and the Female XLR con-
nector is the ouput. The first unit in the chain (master) will use the
female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" unit, press the MODE button until "Slav" is displayed.
Once "Slav" is displayed connect the "Slave" unit to the "Master."
The "Slave" unit will now follow the "Master".
American DJ - www.Americandj.com - Mega Tri 60 User Manual Page 11
© ®
Master-Slave Configuration Mega Tri 60
The ADJ LED RC infrared remote (sold seperately) has many dif-
fernet functions and gives you complete control of your Mega Tri 60.
To control the your desired fixture you must aim the controller at the
front of the fixture and be no more the 30 feet away. To use the ADJ
LED RC you must first activate the fixtures infrared receiver, to acti-
vate the receiver please see the instructions on page 10.
BLACKOUT - Pressing this button will blackout the fixture.
AUTO RUN - This button will run an automatic program. You can set
the number of program cycles by pressing the SPEED button first and
then pressing the "+" and "-" buttons. See Auto Run Mode on page 8
for more information program cycles. You activate strobing by press-
ing the FLASH button, then using the "+" or "-" to adjust the flash
rate.
PROGRAM SELECTION - This button activates static color mode
and program mode. Pressing this button will switch between the two
modes.
In static color mode, use the "+" and "-" buttons to scroll through the
7 static colors. Press the Flash Button to activate strobing and use
the "+" & "-" buttons to adjust the strobe speed.
In program mode, use the "+" and "-" buttons to scroll through the 22
different programs.
Press the SPEED button and use the "+" and "-" buttons to adjust the
programs running speed.
Press the Flash Button to activate strobing and use the "+" & "-" but-
tons to adjust the strobe speed.
Press the Flash Button twice to enter the fade time setting and use
the "+" & "-" buttons to adjust the fade speed.
FLASH - This button will activate the strobe effect. You can control
the flash rate by pressing the "+" and "-" buttons. Press this button
again to exit strobe mode.
SPEED - Press this button and use the "+" & "-" buttons to adjust the
speed of the Auto run.
DMX MODE - This button will let you select which DMX mode you
American DJ - www.Americandj.com - Mega Tri 60 User Manual Page 12
© ®
ADJ LED RC Operation