Getting Started; Turning Power On And Off; Initial System Start-Up; Opening And Closing The Movable Display - Alpine CDA-9833R Owner's Manual

Getting Started

SOURCE/
POWER DISP/B.OUT
RESET

Turning Power On and Off

Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any other button except eject
c.
Press and hold SOURCE/POWER for at least 2
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET with a ballpoint pen or similar
pointed object.

Opening and Closing the Movable Display

Press c.
The movable display will open.
To close the movable display, press c again.
The movable display will close.
• Do not apply shock to the movable display when it is open as it
may result in malfunction of the unit.
• The display may be dim during low temperatures and immediately
after turning on the power. The brightness will return to normal as
time elapses.
• The display will stop at the set tilt angle when closing.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
6
-EN
Rotary encoder
TILT 98 c

Display Tilt Adjustment

The movable display may be adjusted to 3 different tilt angles
depending upon user preference.
Press TILT 98 to adjust the tilt angle of the movable
display.
• The display will close a half minute after the ignition key is turned
to the OFF position.
• The adjusted tilt angle of the display is stored in memory. There is
no need to re-adjust the tilt angle when the power is turned back on.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Changing the Display Type (CDA-9833R only)

There are three selectable display types. You can also deactivate the
display.
Press DISP/B.OUT to switch the display type.
TYPE1 → TYPE2 → TYPE3 → OFF → TYPE1
TYPE1 : The indicator on the left changes in a fixed sequence.
TYPE2 : The indicator on the left changes according to the
setting (see "Setting the Multicolour Illumination" on
page 27)
TYPE3 : The indicator on the left changes according to audio
level.
Switching the Display modes (CDA-9835R
only)
You can select the display pattern mode from three display patterns.
Press DISP/B.OUT to select the desired display
pattern mode.
Each press changes the display patterns.
Basic display of each source → Animation display pattern1 →
Animation display pattern2 → Basic display of each source
Movable display