Alpine CDA-9833R Owner's Manual page 41

1 Antenna Receptacle
Connect to the supplied ISO antenna convertor plug.
2 Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular phone
which provides ground shorting when a call is received.
3 Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4 Dimmer Lead (Orange)
This lead may be connected to the light switch of the
vehicle. This will enable the switched on vehicle's light to
dim the backlighting of the unit.
5 Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse box or
another unused power source which provides (+) 12V only when
the ignition is turned on or in the accessory position.
6 Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
• This lead should be used only for controlling the vehicle's power
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
7 Choke Coil with Fuse Holder (15A)
8 Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's battery.
9 ISO Power Supply Connector
! Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
" Ai-NET Connector
Connect this to the output or input connector of other product (CD
changer, Equalizer, etc.) equipped with Ai-NET.
# System Switch
When connecting a processor using Ai-NET, place this
switch in the EQ/DIV position. When no device is
connected, leave the switch in the NORM position.
• Be sure to turn the power off to the unit before changing the switch
position.
$ Setting the 3WAY/2WAY switch
Set the 3way/2way Switch according to your audio system.
% Power Supply Connector
& ISO Connector (Speaker Output)
( Left Rear (+) Speaker Output Lead (Green)
) Left Rear (–) Speaker Output Lead (Green/Black)
~ Left Front (+) Speaker Output Lead (White)
+ Left Front (–) Speaker Output Lead (White/Black)
, Right Front (–) Speaker Output Lead (Grey/Black)
- Right Front (+) Speaker Output Lead (Grey)
. Right Rear (–) Speaker Output Lead (Violet/Black)
/ Right Rear (+) Speaker Output Lead (Violet)
: Remote Control Interface Connector
To remote control interface box.
; Amplifier Link / Vehicle Display Interface Connector
Outputs Amplifier Link / Vehicle Display Interface control
signals.
Amplifier Link:Connect this to an external Amplifier Link
compatible amplifier, using the (also separately sold)
Amplifier Link box KCE-510M.
Vehicle Display Interface:Connect this to the optional
Vehicle Display Interface box.
• Use the optional splitter cable to connect to both Amplifier Link
box KCE-510M and Vehicle Display Interface box.
• For details about connections, consult your nearest ALPINE
dealer.
< Front Output RCA Connectors
RED is right and WHITE is left.
= Rear Output RCA Connectors
RED is right and WHITE is left.
> Subwoofer Output RCA Connectors
RED is right and WHITE is left.
? DC/DC Converter (CDA-9835R only).
• Do not install the converter at a location subjected to water such
as under the floor mat or air conditioner. This may cause a
malfunction.
• Do not bundle the DC/DC converter cable with other audio cables.
Doing so may induce noise into your system.
• Keep the DC/DC converter away from the Antenna cables and the
rear side of the unit, otherwise noise may be generated when
receiving radio broadcast.
@ Ai-NET Cable (Included with CD Changer)
[ RCA Extension Cable (Sold Separately)
Continued
41
-EN