Alpine IVX-C806 Owner's Manual page 65

Parking Brake Lead Connection
If necessary, use a pinch connector to connect the parking brake lead, etc.
1
Vehicle Cable
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
IVX-C806/IVX-
M706/CVA-1006R
(Monitor and Tuner)
NOTE
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately).
If the switched power (ignition) lead of the IVX-C806/IVX-M706/CVA-1006R is connected directly to the positive (+) post of
the vehicle's battery, the IVX-C806/IVX-M706/CVA-1006R draws some current (several hundred milliamperes) even when
its switch is placed in the OFF position and the battery may be discharged.
Cautions for handling the I/F cord
The I/F cord is used to connect the monitor and the tuner BOX.
Press the LOCK button gently while removing the I/F cord out of the terminal. (See the illustration below.)
If you pull out the lock by force, the lock pins will be forced. This will cause a bad connection.
Some possible problems:
• The power of the unit turns off frequently.
• The display disappears.
• The monitor doesn't open or close.
Pull out the cord before you unlock the pins.
Pinch Connector
Monitor Cable
Stopper
ACC
(Red)
BATTERY
(Yellow)
LOCK button
2
SPST SW (Optional)
Battery
Pliers
63
-EN