Advertisement
Quick Links
Jumper Settings
Stand Alone
Master with Slave Present
Slave to Master
Cable Select
X = PK is a Parking position. The presence or absence of this jumper has no effect on the drive. Labeling
may indicate to place this jumper when configuring as a slave. This is to provide for retention of the jumper
in the event that it is needed later.
J
i
1 of 1
Fireball CR
fireball_cr_jumper.pdf
DS
CS
ON
OFF
ON
OFF
OFF
OFF
OFF
ON
PK
Rsvd
X
OFF
X
OFF
X
OFF
X
OFF
Advertisement
Related Manuals for Quantum Maxtor Fireball CR
Summary of Contents for Quantum Maxtor Fireball CR
- Page 1 Fireball CR fireball_cr_jumper.pdf Jumper Settings Rsvd Stand Alone Master with Slave Present Slave to Master Cable Select X = PK is a Parking position. The presence or absence of this jumper has no effect on the drive. Labeling may indicate to place this jumper when configuring as a slave. This is to provide for retention of the jumper in the event that it is needed later.
- Page 2 IDE / ATA cable connector. Using the jumper pins you can establish the drive Master/Slave configuration. The Maxtor Fireball CR was developed by Quantum Corporation prior to its merger with Maxtor. BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Fireball CR disk drive.
- Page 3 Fireball CR fireball_cr_jumper.pdf Special Considerations Hard drives greater than 2.1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions 4.0 through 6.22 allow a maximum primary partition / logical drive size of 2.1GB and are limited to 8.4GB in physical drive capacity.