Optimise Standby; Replenish Salt And Rinse Aid Reminders - Miele Dishwashers Operating Instructions Manual

Settings menu

Optimise standby

To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or a few minutes after the end
of the programme. The display and
indicator lights will go out and only the
Start/Stop indicator light will flash
slowly.
If the dishwasher is not switched off at
the end of the programme, it will switch
off completely after a few minutes in
Standby mode.
The Optimise standby function can be
deactivated if wished. The display and
the indicator lights will not go out, and
the time lapse before the dishwasher
switches off will increase to approx. 6
hours, resulting in higher energy
consumption.
^ Select the setting you want, and
confirm your selection with the
middle button underneath the
display.
The dishwasher will not switch into
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be replenished or there is a fault.
70
If you only use combination
products containing salt and rinse
aid in your dishwasher, you can
switch off the reminders to replenish
salt and rinse aid so that the
dishwasher will go into Standby
despite a lack of salt or rinse aid.
You cannot switch off fault
messages.
Replenish salt and rinse aid
reminders
If you only ever use combination
products containing salt and rinse aid
in your dishwasher, you can switch
both of these reminders off if you wish.
The DetergentAgent function will not be
affected by this.
^ Select the setting you want, and
confirm your selection with the
middle button underneath the
display.
If you switch to using detergent that
does not contain salt or rinse aid, it
is important to remember to
replenish the salt and rinse aid and
to switch the reminders back on.