Audi A5 Owner's Manual page 33

document_0900452a8179700c.book Seite 31 Donnerstag, 22. März 2007 10:19 10
– Switch off the engine.
– Check the function displayed. Obtain professional assist-
ance if necessary.
The red symbols indicate a Priority 1 fault (serious malfunction).
Should a Priority 1 fault occur, a red warning symbol will appear at
the top of the display ⇒ page 30, fig. 25. The symbol is accompa-
nied by a driver message giving you more information about the
fault. This symbol is accompanied by three warning chimes. The
symbol will keep flashing until the fault is corrected.
If several Priority 1 faults are detected at the same time, the symbols
are displayed one after the other for about 2 seconds at a time.
This message will disappear after about 5 seconds, but you can call
it up again at any time by pressing the

Alternator fault

Fault in brake system/ parking
brake

Coolant level too low / coolant
temperature too high

Engine oil pressure too low

Fault in the steering system

Ignition lock defective

Alternator fault

If the symbol flashes in the instrument cluster display, there is an
alternator fault or a fault in the vehicle's electrical system. In addi-
tion, a message will appear. This message will disappear after about
Controls
5 seconds, but you can call it up again at any time by pressing the
SET
You should normally be able to drive to the next available qualified
workshop. However, you should avoid using electrical equipment
that is not absolutely necessary because this will drain the battery.
If the coolant warning lamp
as well as the alternator warning lamp while driving ⇒ page 32, stop
the vehicle immediately and switch off the engine. In this case the
coolant pump is no longer being driven, and there is a risk of engine
damage.
button ⇒ page 30.
SET Fault in the brake system
A fault in the brake system should be corrected as soon as
⇒ page 31
possible.
⇒ page 31
If the symbol
brake system. The symbol is accompanied by a driver
⇒ page 32
message giving you more information about the fault. This
message will disappear after about 5 seconds, but you can
⇒ page 33
call it up again at any time by pressing the
⇒ page 33 Stop vehicle and check brake fluid level
– Stop the vehicle.
⇒ page 34
– Check the brake fluid level ⇒ page 238.
– Obtain professional assistance if necessary.
Warning! Fault in ABS brake system. Contact
workshop
– Drive carefully to the nearest qualified workshop and
Safety Driving tips General maintenance
Driver information system
button.
Caution

in the instrument display lights up


flashes in the display, there is a fault in the
have the fault rectified ⇒
.
Self-help
31
button:
SET
Technical data