Audi A5 Owner's Manual page 158

document_0900452a8179700c.book Seite 156 Donnerstag, 22. März 2007 10:19 10
156 HomeLink
Activating the garage door opener drive unit
– Locate the programming button on the garage door
drive. The exact location and colour of the button may
vary depending on the type of garage door opener.
– Press the programming button on the door drive unit
(this will normally cause a "programming mode indicator
lamp" on the unit to light up). You now have about 30
seconds to start and complete the programming of the
HomeLink control button on the operating unit.
Programming at the operating unit in the
headliner
– Press and release the already programmed HomeLink
button.
– Press the HomeLink button again to complete rolling
code programming.
After programming at the operating unit in the headliner, the
garage door opener should recognize the HomeLink signal and
respond when the HomeLink button is pressed. Now the other
control buttons can be programmed as required.
Note
Having a second person assist you makes programming of the
rolling code easier and faster. For some makes of garage door
openers the HomeLink button may have to be pressed a third time
to complete the training sequence.
If you encounter problems programming the rolling code you
may find helpful information in the operating instructions of the
garage door opener or other device you wish to operate.
Applies to vehicles: with HomeLink
Operating HomeLink
The programmed devices are activated by means of the
HomeLink control buttons in the headliner.
– Make sure that the ignition is on.
– Press the programmed HomeLink button ⇒ page 154,
fig. 171. The device assigned to that button (e.g. garage
door) will be activated.
The HomeLink indicator diode ⇒ page 154, fig. 171 will light up
when you press the button.
Applies to vehicles: with HomeLink
Erasing the button programming
You can erase the complete HomeLink programming by
pressing the two outer buttons.
– Switch on the ignition (do not start the engine).
– Press and hold down the two outer buttons until the indi-
cator diode starts to flash ⇒ page 154, fig. 171.
– Then release the buttons.
After the programming of the HomeLink buttons has been erased,
the system will return to the training mode and is ready to be re-
programmed at any time.
Note
Programmed buttons cannot be erased individually.
For security reasons it is advisable to erase the programming of
the HomeLink buttons prior to selling your vehicle.