Replacing The Lamp; Closing The Door - Electrolux ERA37300W User Manual

Electrolux fridge
Table of Contents

Advertisement

Problem
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the re-
frigeration is too high.
The appliance does not
operate.
The fan does not operate. The compressor does not oper-
The lamp does not work.
Door interferes with ven-
tilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

1. Disconnect the appliance from the power
socket.
2. Disassemble the lamp by using a screw-
driver in the recess on the lamp insert.
3. Assemble a new lamp by guiding it into a
centred position and press until it snaps.
Use a halogen bulb of the same type,
maximum rating of 20 W
4. Reconnect the appliance.
Possible cause
The door is not closed correctly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too high. Let the food temperature decrease
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
ate.
The lamp is defective.
The door has been open to long. Close the door.
The appliance is not levelled.
The appliance is not levelled.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
to room temperature before stor-
age.
Make sure that there is cold air cir-
culation in the appliance.
Insert smaller quantities of food to
be cooled at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
This is correct. The fan runs only
when the compressor is running
Refer to "Replacing the lamp".
Refer to "Levelling".
Refer to "Levelling".

Closing the door

1. Clean the door gaskets.
electrolux 11
Solution

Advertisement

Table of Contents
loading

This manual is also suitable for:

Era37300x

Table of Contents