Table of Contents
Advertisement
DC PANEL OPERATION
•
Turn on all 24V breakers.
For safety, Windlass Control breaker should be OFF except when using the windlass.
Holding Tank Pump and Raw Water Wash down Pump should be OFF.
NOTE: all bilge pump breakers should be ON and switches should be set to
automatic all the time.
The 24-volt circuit breakers are located on the top of the DC panel. Only use the light you
need. There are sufficient lights and other 24-volt devices to drain the house
batteries of power if they were all left on overnight.
G. BATTERY SWITCHES
The battery switches are located in the engine room on the aft bulkhead immediately to
the left as you enter the engine room. These are normally left in the 'On ' position.
July 21, 2012
18
Advertisement
Table of Contents
