Check The Jumper Settings - ECS K7VZA Manual

Check the Jumper Settings

Check the mainboard jumpers to ensure that the board is
configured correctly.
How to Set Jumpers
A jumper consists of two or more pins mounted on the
mainboard. Some jumpers might be arranged in a series with
each pair of pins numbered differently. Jumpers are used to
change the electronic circuits on the mainboard. When a jumper
cap (or shunt) is placed on two jumper pins, the pins are SHORT.
If the jumper cap is removed (or placed on just a single pin), the
pins are OPEN.
Open
Short
In this manual, all the jumper illustrations clearly show the pin
numbers. When you are setting the jumpers, make sure that the
jumper caps are placed on the correct pins to select the function
or feature that you want to enable or disable.
This illustration shows a 2-pin jumper.
When the jumper cap is placed on
both pins, the jumper is SHORT. If
you remove the jumper cap, or place
the jumper cap on just one pin, the
jumper is OPEN.
This illustration shows a 3-pin jumper.
The jumper cap is placed on pins 2
and 3, so this jumper setting is
SHORT PINS 2-3.
This illustration shows the same 3 -pin
jumper. The jumper cap is placed on
pins 1 and 2, so this jumper setting is
SHORT PINS 1-2.
13