Table of Contents
Advertisement
7.
Connect the CPU Cooling Fan
power cable connector to the
CPUFAN connector.
•
To achieve better airflow rates and heat dissipation, we suggest that
Notes:
you use a high quality fan with 4800 rpm at least.
•
CPU fan and heatsink installation procedures may vary with the type of
CPU fan/heatsink supplied. The form and size of fan/heatsink may also
vary.
Installing Memory Modules
This mainboard accommodates two 184-pin 2.5V unbuffered Double Data
Rate
(DDR)
SDRAM
DDR266/DDR333/DDR400 memory modules, the memory bus can run up to
133/166/200 MHz.
The DDR SDRAM DIMMs can synchronously work with 100 MHz or operates
over a 400 MHz (overclock) system bus. You must install at least one memory
module in order to use the mainboard. Each module can install up to 1GB;
total maximum memory capacity.
Do not remove any memory module from its antistatic packaging until
you are ready to install it on the mainboard. Handle the modules only by
their edges. Do not touch the components or metal parts. Always wear
a grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1.
This mainboard supports unbuffered DDR SDRAM only. Do not attempt to
insert any other type of DDR SDRAM into the slots.
2.
Push the latches on each side of the DIMM slot down.
3.
Align the memory module with
the slot. The DIMM slots are
keyed with notches and the
DIMMs are keyed with cutouts
so that they can only be in-
stalled correctly.
DIMM
sockets.
When
15
you
install
Advertisement
Table of Contents
