Table of Contents
Advertisement
Burners characteristics
BURNER
Auxiliary
Semi-rapid
Rapid
Electrical connection
The unit is preset to work with a voltage of single phase
230 V.
Before making the connection make sure that:
— the energy power available in the user's house is
sufficient for the normal supply of this appliance (see
rating plate).
— the unit is correctly connected to earth through a
suitable plug and according to the installation country
Laws.
— the socket or the omnipolar switch used for the
connection must be easilv reached with the installed
appliance.
The appliance is supplied with electric cord: you have to
install a plug fit for the load shown in the serial number
plate. The plug has to be connected to an adequate
socket.
If you wish to directly connect to the mains, you have to
interpose an omnipolar switch with a minimum opening
between contacts of 3 mm, between the unit and the
mains, complying with the existing regulations. The
brown live wire (originating from the clamp of the cooker
junction box) must always be connected to the phase
of the mains supply. In any case, the supply cord must
be positioned in such a way as it doesn't reach in any
point a temperature higher by 50°C than the room tem-
perature.
Should the supply cord need to be replaced, use only
the following cable types:
H05RR-F / H05VV-F / H05V2V2-F (T90). It is necessary
that the yellow/green earth wire is about 2cm longer than
the live and neutral ones.
After the connection, test the heating elements for about
3 minutes to ensure that they are working correctly.
The manufacturer refuses any responsability in
cases where normal safety measures are not
observed.
Normal power
Reduced power
kW
1
2
Natural gas:
3
LPG : 2,8
NATURAL GAS
Mark
1/100
kW
mbar
0,33
70
0,095
0,45
96
0,190
0,65
119
0,286
Phase
FO 0480
LPG
m
/h
Mark
3
1/100
G20
G25
G 30
20
25
mbar
0,111
50
0,221
71
0,332
86
Ground (yellow - green)
g/h
G 31
72,5
71,5
145
143
203
200
Neutral
wire
89
Advertisement
Table of Contents
