Safety; Precautions - Christie E Series User Manual

1.

SAFETY

1.1

Precautions

Installers, service trained operators and all other users must maintain a safe
operating environment at all times. Read through this document in its entirety
and understand all warnings and precautions before attempting to operate this
projector.
WARNING
Do not look into the projector lens when the lamp is on. The bright light

may result in permanent eye damage.
To reduce the risk of fire or electric shock, do not expose this projector to

rain or moisture.
Do not open or disassemble the projector as this may cause electric shock.

When replacing the lamp, allow the unit to cool down, and follow all

replacement instructions.
This projector will detect the life of the lamp. Make sure the lamp is

changed when a warning message is displayed.
When you switch the projector OFF, ensure that the cooling cycle is

complete before disconnecting the power. Allow 90 seconds for the
projector to cool down.
Cooling of the lamp during the ignition phase should be avoided. This may

lead to ignition failures. After a successful lamp ignition, keep the lamp
burning for at least 15 minutes to maintain lamp life.
When the lamp is approaching the end of its life, the message

approaching the end of its useful life in full power operation
the screen. Contact your local reseller or service center to change the
lamp as soon as possible.
All installation and maintenance procedures must be performed by a

Christie accredited service technician.
FIRE HAZARD. Keep hands, clothes and all combustible material away

from the concentrated light beam of the projector. Position all cables where
they cannot contact hot surfaces or be pulled or tripped over.
E Series User Manual
020-000287-01 Rev. 1 (01-2011)
Section 1: Safety
Lamp is
"
appears on
"
1-1