Lamp Installation - Christie E Series User Manual

3.6

Lamp Installation

The projector automatically detects the lamp life. When the lamp life is nearing
the end of use, you will receive a warning message. When you see this
message, please contact your local reseller or service center to change the
lamp as soon as possible. Make sure the projector has been cooled down for
at least 30 minutes before changing the lamp.
Installation Steps:
1. Turn off the lamp:
Note the number of the lamp that
needs to be replaced on the "Current
Lamp" menu.
Turn the projector OFF and
disconnect the power cord.
2. Wait for lamp cool down:
Allow the projector to cool down for
at least 30 minutes.
3. Open the lamp door:
Unscrew the two screws on the
lamp door.
Open the lamp door located on the
top-rear of the projector.
4. Remove the old lamp:
Loosen the two captive screws
securing the lamp.
Lift up the lamp by grasping handle
and remove the lamp module slowly
and carefully.
5. Install the new lamp:
Replace the lamp with a new one
and tighten two screws. Make sure
the lamp is set properly and secure.
6. Close the lamp door:
Put the Lamp Door back and tighten
two screws.
7. Reset the lamp hours:
Turn the projector ON and use
"Reset Lamp Hours" after the lamp
module is replaced.
E Series User Manual
020-000287-01 Rev. 1 (01-2011)
A
B
" after the lamp after the lamp
Section 3: Installation
3-9