Troubleshooting; Playback Using The Remote Control Unit - Denon DCD-1650R Operating Instructions Manual

Stereo cd player
Table of Contents

Advertisement

ENGLISH

TROUBLESHOOTING

If the CD player does not seem to be functioning properly, check the following:
Disc holder does not open or close.
• Is the power on?
When a disc is loaded, 00
• Is the disc loaded properly?........................................See page 8
• Is an unrecorded CD-R or CD-RW disc inserted? .....See page 13
• Is a non-finalized CD-R or CD-RW disc inserted?......See page 13
When the
PLAY button is pressed, playback does not start.
1
• Is the disc dirty or scratched?...................................See page 13
There is no sound, or it is distorted.
• Is the output cord properly connected to
the amplifier?..............................................................See page 7
• Have the amplifier controls been set correctly?

PLAYBACK USING THE REMOTE CONTROL UNIT

The accessory RC-281 remote control unit can be used to control
the CD player from a convenient distance.
(1) Inserting the dry cell batteries
1. Remove the battery cover on the back of the remote control
unit.
2. Insert two R6P (standard size AA) dry cell batteries with correct
polarity as indicated inside battery compartment.
3. Replace the battery cover.
Notes on the Batteries
• The remote control unit uses standard size AA dry cell batteries.
• The batteries will need to be replaced approximately once a year
Replacement may be necessary earlier depending on how much
the remote control unit is used.
• If, in less than a year from the time new batteries were inserted,
the remote control fails to operate the CD player from a near-by
position, it is time to replace the batteries.
• The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
• Insert the batteries properly, following the polarity diagram inside
the battery compartment, in other words make sure (+) and (-)
terminals are properly aligned.
14
0000 is displayed.
00
A specific section of the disc will not play.
• Is the disc dirty or scratched?...................................See page 13
Programmed playback does not work.
• Have programming been properly
done? .......................................................See pages 9,10 and 15
Incorrect operation when buttons on the remote control are
pressed.
• Is the remote control unit being operated
too far from the CD player? ......................................See page 14
• Are there obstacles blocking the ray?
• Is the remote control sensor exposed to strong light?
• Are the batteries exhausted?
• Batteries are prone to damage and leakage.
Therefore:
• Do not combine new batteries with used ones.
• Do not combine different types of batteries.
• Do not jumper opposite poles of the batteries, expose them to
heat, break them open nor expose of them in open fire.
• If the remote control unit is not to be used for a long period of
time, remove the batteries from the unit.
• If the batteries have leaked, remove any traces of battery fluid
from the battery compartment, wiping thoroughly with a dry
cloth. Then insert new batteries.
(2) Directions for Use
• Operate the remote control unit while pointing it towards the
remote control sensor on the CD player (see below).
Approx. 8 m
When a remote control signal is received, the remote control
indicator on front of the CD player lights briefly.
• The remote control unit can be used at a distance up to 8 meters
in a straight line from the CD player. This distance decreases if
there are obstructions blocking the signal path or when the
remote control unit is operated at an angle from the remote
control sensor.
• The buttons on the remote control unit have identical functions
with those on the CD player.
However, the following functions cannot be remote controlled:
Power ON/OFF.
Cautions on Use
• Do not press the operation buttons on the main unit and on the
remote control unit simultaneously, as this will result in
malfunction.
• The remote control unit may not operate properly if the remote
control sensor is exposed to direct sunlight or strong artificial
lighting, or if there is an object between the remote control unit
and the remote control sensor.
Right 30°
Left 30°

Advertisement

Table of Contents
loading

Table of Contents