Beam DriveDOCKExtreme Installation & User Manual page 14

Step 6 - Connect the Intelligent Handset
(Optional - Extra Order)
The Intelligent handset provides the user with a dial pad and LCD display
and allows the user to make calls or send/receive SMS without having
access to the Extreme handset.
The Intelligent handset is enabled when it is removed from the cup.
However, if both the Intelligent and Privacy handsets are enabled, the
Privacy handset has the higher priority.
Step 7 - Connect the DC power cable to the DriveDOCK Extreme
Power is supplied to the DriveDOCK Extreme via the 4-way Microfit®
connector using the DC power cable.
The DC power cable has three wires, RED, BLACK and YELLOW.
The RED and BLACK wires are used for the power connection. The
YELLOW wire can be connected to a vehicle's accessories, ignition or other
similar circuits to control the ON/OFF status of the DriveDOCK Extreme in
synchronization with a vehicles operation.
By default, the DriveDOCK Extreme will stay on for 20 minutes after this input
is switched off and if a call is in progress while this occurs, the DriveDOCK
Extreme will stay on for 20 minutes after the call is terminated.
Please follow the steps below to connect the DC power cable to the vehicle
battery power and the DriveDOCK Extreme.
1. Place, but do not connect, the 4-way Microfit connector on the DC
power cable beside the 4-way power connector on the rear cable loom
of the DriveDOCK Extreme.
2. Route the other end of the DC power cable to the connection point.
DO NOT apply power until the following steps are completed.
3. Connect the black wire to the negative terminal of the battery or the
vehicle chassis (if negatively grounded chassis).
4. Connect the RED wire to the positive terminal of the battery. It is
recommended to add a 3A fuse (supplied) between them.
26
RED (+) Vin 9 to 32VDC
BLACK (-) OV Power Ground
YELLOW (IGN) Ignition / Accessory
5. Connect the YELLOW wire to the vehicle accessory power. If the
accessory power is unavailable, this may be connected to a vehicle
ignition voltage. It is recommended to add a 1A (supplied) fuse between
them. The accessory wire enables the DriveDOCK Extreme to turn on
and off as the vehicle key is enabled or disabled. If this function is not
required, the YELLOW wire MUST be connected to the RED wire.
6. Once all the components have been installed, connect the 4-way
Microfit connector to the DriveDOCK Extreme and turn the DOCK on.
Wiring for a Marine Application
When installed in a marine application using the DC power cable, the
YELLOW wire can be wired to a suitable panel switch which will allow the
DriveDOCK Extreme to be turned off when not in use.
To Battery Positive Terminal
(3A Fuse recommended)
To Negative Terminal or chassis
To ACC switched power
(1A Fuse recommended)
27